Tongue controlled speaking robot for paralyzed/physically handicapped persons

Also Available Domains Arduino

Project Code :TEMBMA2693

Objective

The main objective oft this project is By using wireless technology. The User he will control the robot based on tongue movements of the patient

Abstract

Tongue Drive system (TDS) is a tongue-operated unobtrusive wireless assistive technology, which can potentially provide people with severe disabilities with effective computer access and environment control. It translates users’ intentions into control commands by detecting and classifying their voluntary tongue motion utilizing a small permanent magnet, secured on the tongue, and an array of magnetic sensors mounted on a headset outside the mouth or an orthodontic brace inside.

The control system consists of Magnetic sensor and microcontroller. Microcontroller collects data from the sensor and transmits the data through the ZIGBEE transmitter. At receiver end ZIGBEE receiver receives the data and fed as input to the micro controller. The controller performs the corresponding actions i.e., Robot movement. This Project consists of two Microcontroller Units, Robot, Magnetic sensor and wireless communication through ZIGBEE technology. Robot is made up of High torque Geared DC Motors, the Motors Directions can be changed through the set of instructions given from the Magnetic sensor and the action of these Instructions is already loaded into the Microcontroller using Embedded C programming.

The ZIGBEE receiver provides the information to the microcontroller (on board computer) from ZIGBEE transmitter and the controller judges whether the instruction is right movement or left movement based on the tongue movement and controls the direction. This device is portable and this system operation is entirely driven by wireless technology.

Keywords: Arduino uno, WSN, Zigbee, Magnetic sensors.

NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.

Block Diagram

Specifications

Hardware Requirements:

  • Arduino uno
  • Zigbee transmitter
  • Zigbee receiver
  • L293D Motor driver
  • DC Motor
  • Magnetic sensor

Software Requirements:

  • Arduino IDE
  • Embedded c
  • Fritzing

Learning Outcomes

  • Arduino uno and NodeMCU Pin diagram and Architecture
  • How to install arduino IDE Software
  • Basic coding in embedded C
  • Working of L293D Motor driver
  • Interfacing L293D Motor driver with arduino uno
  • Interfacing DC motor with arduino uno
  • Working of magnetic sensors
  • Interfacing magnetic sensor with arduino uno
  • Introduction to serial communication
  • Working zigbee module
  • How to interface zigbee with arduino uno?
  • About Project Development Life Cycle:
    • Planning and Requirement Gathering( software’s, Tools, Hardware components, etc.,)
    • Schematic preparation 
    • Code development and debugging
    • Hardware development and debugging
    • Development of the Project and  Output testing
  • Practical exposure to:
    • Hardware and software tools.
    • Solution providing for real time problems.
    • Working with team/ individual.
    • Work on Creative ideas.
  • Project development Skills
    • Problem analyzing skills
    • Problem solving skills
    • Creativity and imaginary skills
    • Programming skills
    • Deployment
    • Testing skills
    • Debugging skills
    • Project presentation skills
    • Thesis writing skills

Demo Video

mail-banner
call-banner
contact-banner
Request Video