SMART Speed Setter and Calibrator for Speed Control devices
Also Available Domains Arduino|Raspberry pi
Objective
The main objective of the project is to use Smart speed setter that is used to calibrate the speed control devices, which indicates and limits the over speeding of automobiles.
Abstract
Speed control is in the need of the hour due to the increased rate of accidents reported in our day-to-day life. During 2011, in India a whole of 4, 97,686 road accidents were reported which is a result of lack of speed control and violating the road rules. Road accidents can be prevented by adopting measures such as Traffic management, improving quality of road infrastructure and safer vehicles.
The existing techniques still doesn’t able to reduce the number of accidents. Hence there is a need to implement Intelligent Speed Adaptation (ISA) in which vehicles speed can be automatically controlled by various limit techniques which are based on zones, highway, traffic density etc.
When the system activated then our vehicle is controlled at given limited speed or below that limiting speed and cannot exceed beyond that limit till the next color strip crossed. This reduces the road accidents and gets driving comfort for the driver, after implementation of this automatic speed control system. If the vehicle exceeds the limit then the message will send and also buzzer will alarm.
Keywords: Speed control, GPS, Arduino UNO.
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
Hardware Requirements:
- Arduino Uno
- 12V Adapter
- Connecting wires
- Buzzer
- Relay
- GPS Module
- GSM Module
- 16x2 LCD
Software Requirements:
- Arduino IDE
- Embedded C
- Fritzing
Learning Outcomes
- Arduino UNO Pin diagram and Architecture
- How to install arduino IDE Software
- Setting up and Installation procedures for Arduino UNO
- Introduction to Arduino IDE
- Commands in Arduino
- How to install Libraries?
- Basic coding in arduino
- Introduction to Serial Communication
- Working of GPS
- Working of GSM
- How to interface GPS with arduino?
- How to interface GSM with arduino?
- Working of relay
- Working of LCD
- How to interface relay, LCD with arduino?
- How to interface buzzer with arduino?
- About Project Development Life Cycle:
- Planning and Requirement Gathering( software’s, Tools, Hardware components, etc.,)
- Schematic preparation
- Code development and debugging
- Hardware development and debugging
- Development of the Project and Output testing
- Practical exposure to:
- Hardware and software tools.
- Solution providing for real time problems,
- Working with team/ individual,
- Work on Creative ideas.
- Project development Skills
- Problem analyzing skills
- Problem solving skills
- Creativity and imaginary skills
- Programming skills
- Deployment
- Testing skills
- Debugging skills
- Project presentation skills
- Thesis writing skills
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
6-2-85/B, Old Maternity Hospital Road, Thyagaraja Nagar, Tirupati, Andhra Pradesh – 517501
+91 9030333433
+91 9393939065
0877-2261612
Disclaimer - Takeoff Edu Group Projects are not associated or affiliated with IEEE in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, not projects of or by IEEE.
