Seat Belt Alarm and Controlling of Vehicle
Objective
The main objective of this project is to alert driver about Seat belt and controlling vehicle accordingly
Abstract
Most of the accidents are occurred because of violation of rules. Result of this major accidents happened. When accidents that careless mistake makes loss of life of driving person and near person. More injuries for driving person and near person only than back sitting persons. In our day-to-day life we are careless in our safety while driving in vehicles for this we have to introduce some techniques to do these precautions compulsory. While driving car wearing seat belt is important that can save our life during accident periods .But most of us are careless to wear seatbelt. Driver will be unable to start vehicle without wearing seat belt. The technology connects the drivers and the co passenger seat belts with the Ignition system such that without fastening the seat belts, the engine will not start. If the driver unfastens their seat belt is removed after starting off vehicle, the control unit will disengage the power input to the ignition switch after 30 seconds resulting in halt position.
Keywords: Arduino, Magnetic Sensor, Gas Sensor, Potentiometer, GSM, LCD, face recognition
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
Hardware Requirements:
- Arduino
- Magnetic Sensor
- Gas Sensor
- Potentiometer
- Buzzer
- GSM
Software Requirements:
- Arduino IDE
- Embedded C
- Python
Learning Outcomes
- Arduino pin diagram and architecture
- How to install Arduino IDE software
- Setting up and Installation procedures for Python3 IDLE and Arduino IDE.
- Commands in Python.
- Basic coding in Python.
- Introduction to Arduino IDE
- Basic coding in Arduino IDE
- Working of Magnetic Sensor
- Interface Magnetic Sensor with Arduino?
- Working of Potentiometer
- Interface Potentiometer with Arduino?
- Working of GSM
- Interface GSM with Arduino?
- Working of Gas Sensor
- Interface Gas Sensor with Arduino?
- Working of power supply
- Working of LCD
- Interface LCD with Arduino?
- How to do Face Recognition in Python?
- Interface Buzzer with Arduino?
- About Project Development Life Cycle:
- Planning and Requirement Gathering (software’s, Tools, Hardware components, etc.,)
- Schematic preparation
- Code development and debugging
- Hardware development and debugging
- Development of the Project and Output testing
- Practical exposure to:
- Hardware and software tools.
- Solution providing for real time problems.
- Working with team/ individual.
- Work on Creative ideas.
- Project development Skills
- Problem analyzing skills
- Problem solving skills
- Creativity and imaginary skills
- Programming skills
- Deployment
- Testing skills
- Debugging skills
- Project presentation skills
- Thesis writing skills
Related Projects
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
Disclaimer - Takeoff Edu Group Projects, are not associated or affiliated with IEEE, in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, and not projects of or by IEEE.
