LPG Weight and Leakage Monitoring System
Objective
The main objective of this project is to monitor LPG cylinder weight and to give alert by sending an SMS
Abstract
Now days we all are very busy in our daily life and it is difficult to know the status of LPG gas cylinder. If LPG is going to finish without informing us it can create very difficult condition for cooking etc. This project is used to continuously monitor the weight of the LPG gas cylinder. Many times we observe that in our home whenever LPG gas cylinder is empty, then we give request for new cylinder at the office of LPG gas provider. Many times it happens that because of shortage of LPG gas cylinder, there is delay in providing gas cylinder. To overcome this drawback we introduced this system. In this system, we proposed an LPG Gas Weight and Leakage Detection System Using IOT. This is useful in various applications in homes and hotels. Our proposed design can help us to avoid such kind of problem in our daily life. Our design is based on microcontroller, it can track LPG emptiness all the time if LPG is very close to finish or at empty level then it can alert by sending SMS to owner In addition it can provide safety also by using sensor it can detect LPG leakage & start alarm.
Keywords: Leakage Monitoring, Load cell, GSM, Arduino Nano.
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
- Arduino Nano
- Gas Sensor
- Load Cell
- LCD
- 4-Bit PCB with Potentiometer
- GSM Module
- Buzzer
- Power Supply
- Arduino IDE
- Embedded C
- Fritzing
Learning Outcomes
- Arduino pin diagram and architecture
- How to install Arduino IDE software
- Setting up and installation procedure for Arduino
- Introduction to Arduino IDE
- Basic coding in Arduino IDE
- Working of Gas Sensor & Load Cell
- Interface of Gas Sensor & Load Cell with Arduino?
- Working of LCD
- Interface LCD with Arduino?
- Working of GSM
- Interface GSM with Arduino?
- About Project Development Life Cycle:
- Planning and Requirement Gathering (software’s, Tools, Hardware components, etc.,)
- Schematic preparation
- Code development and debugging
- Hardware development and debugging
- Development of the Project and Output testing
- Practical exposure to:
- Hardware and software tools.
- Solution providing for real time problems.
- Working with team/ individual.
- Work on Creative ideas.
- Project development Skills
- Problem analyzing skills
- Problem solving skills
- Creativity and imaginary skills
- Programming skills
- Deployment
- Testing skills
- Debugging skills
- Project presentation skills
- Thesis writing skills
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
6-2-85/B, Old Maternity Hospital Road, Thyagaraja Nagar, Tirupati, Andhra Pradesh – 517501
+91 9030333433
+91 9393939065
0877-2261612
Disclaimer - Takeoff Edu Group Projects are not associated or affiliated with IEEE in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, not projects of or by IEEE.
