IOT Based Wireless Sensor Network for Air Pollution Monitoring System
Objective
The main objective of this project is to monitor the pollution level in the air by using the monitoring parameters such as MQ2 sensor, MQ135 sensor and DHT11 sensor.
Abstract
The level of pollution has increased with times by lot of factors like the increase in population, increased vehicle use, industrialization and urbanization which results in harmful effects on human wellbeing by directly affecting health of population exposed to it. In order to monitor In this project we are going to make an IOT Based Air Pollution Monitoring System in which we will monitor the Air Quality over a web server using internet and will trigger a alarm i.e., message will be sent when the air quality goes down or above beyond a certain level, means when there are sufficient amount of harmful gases are present in the air like CO2, smoke, alcohol, benzene andNH3. It will show the air quality on the LCD and as well as on webpage so that we can monitor it very easily. In this IOT project, you can monitor the pollution level from anywhere using your computer or mobile.
Keywords: Arduino uno, MQ2 sensor, MQ135 sensor, LCD, DHT11 sensor, GSM/GPRS, power supply
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
Hardware Requirements:
- Arduino Uno
- MQ2 sensor
- MQ135 sensor
- DHT11 sensor
- LCD
- GSM/GPRS
- Power supply Board
- 12V Adapter
Software Requirements:
- Arduino IDE
- Fritzing
Learning Outcomes
- Arduino pin diagram and architecture
- How to install Arduino IDE software
- Setting up and installation procedure for Arduino
- Introduction to Arduino IDE
- Basic coding in Arduino IDE
- Working of MQ2 sensor
- Interface MQ2 sensor with Arduino?
- Working of MQ135 sensor
- Interface MQ135 sensor with Arduino?
- Working of GSM/GPRS
- Interface GSM/GPRS with Arduino?
- Working of DHT11 sensor
- Interface DHT11 sensor with Arduino?
- Working of LCD
- Interface LCD with Arduino?
- Working of power supply
- About Project Development Life Cycle:
- Planning and Requirement Gathering( software’s, Tools, Hardware components, etc.,)
- Schematic preparation
- Code development and debugging
- Hardware development and debugging
- Development of the Project and Output testing
- Practical exposure to:
- Hardware and software tools.
- Solution providing for real time problems.
- Working with team/ individual.
- Work on Creative ideas.
- Project development Skills:
- Problem analyzing skills
- Problem solving skills
- Creativity and imaginary skills
- Programming skills
- Deployment
- Testing skills
- Debugging skills
- Project presentation skills
- Thesis writing skills
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
6-2-85/B, Old Maternity Hospital Road, Thyagaraja Nagar, Tirupati, Andhra Pradesh – 517501
+91 9030333433
+91 9393939065
0877-2261612
Disclaimer - Takeoff Edu Group Projects are not associated or affiliated with IEEE in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, not projects of or by IEEE.
