IOT Based Password Based Circuit Breaker
Also Available Domains IOT
Abstract
The password based circuit breaker control system is a system that access only specified password to control the circuit breaker. Here, there is also a provision of changing the password. The system is fully controlled Arduino board that should be connected to ATMEGA328P series microcontroller that is 8 bit microcontroller. WIFI module is interfaced to the microcontroller to enter the password while a relay driver IC is used to switch ON / OFF the loads through relays. The complete circuit is built with on board power supply. The power supply consists of a step down transformer 230/12V, which steps down the voltage to 12V AC. This is converted to DC using a Bridge rectifier. The ripples are removed using a capacitive filter and it is then regulated to +5V using a voltage regulator which is required for the operation of the microcontroller and other components.
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
6-2-85/B, Old Maternity Hospital Road, Thyagaraja Nagar, Tirupati, Andhra Pradesh – 517501
+91 9030333433
+91 9393939065
0877-2261612
Disclaimer - Takeoff Edu Group Projects are not associated or affiliated with IEEE in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, not projects of or by IEEE.
