Investigation into Unconscious Driver's Posture Change and Body Injury Affected by Motorized Seat-Belt Pretension in Full-Frontal Collision with Automatic Emergency Braking
Objective
when emergency braking the vehicle the driver effected by seat-belt tightening the driver it causes injury to the driver.so, that seat-belts are set with different pre-tightening levels, and different initial speeds are set for each level.
Abstract
In the process of importing subjects from one place to another, the drivers has to travel to longer distance and it might take days sometimes. They may get sleepy and fell asleep while driving, this might cause accidents. To eradicate this problem, this project is been introduced.
Here we are attach MEMs sensor to driver, if the position of driver changes (means turn down or looking side or turn back) which leads to cause accidents, at that time it intimates that driver position changes.
If any accidents occur that time suddenly the driver temperature and heart beat changes or it exceeds the threshold level then the alert message will send to the stack holder through GSM. So that we can save the driver life.
Keywords: Arduino Uno, temperature sensor, heart beat sensor, MEMS sensor, LCD, buzzer, GSM
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
Hardware Requirements:
- Arduino
- Temperature sensor
- Heartbeat sensor
- MEMS sensor
- 16x2 LCD
- GSM
- Buzzer
- Connecting wires
- Power supply
Software requirements:
- Arduino IDE
- Embedded C
- Fritzing
Learning Outcomes
- Arduino Uno Pin diagram and Architecture
- How to install arduino IDE Software
- Setting up and Installation procedures for arduino
- Introduction to arduino IDE
- Commands in arduino
- Basic coding in Embedded C
- Working of temperature sensor
- How to interface temperature sensor with arduino uno?
- Working of heartbeat sensor
- How to interface heartbeat sensor with arduino uno?
- Working of MEMS sensor
- How to interface MEMS sensor with arduino uno?
- Working of 16x2 LCD
- How to interface 16x2 LCD with arduino uno?
- Working of relay
- How to interface relay and buzzer with arduino uno?
- Introduction to serial communication
- Working of GSM
- How to interface GSM with arduino uno?
- About Project Development Life Cycle:
- Planning and Requirement Gathering( software’s, Tools, Hardware components, etc.,)
- Schematic preparation
- Code development and debugging
- Hardware development and debugging
- Development of the Project and Output testing
- Practical exposure to:
- Hardware and software tools.
- Solution providing for real time problems.
- Working with team/ individual.
- Work on Creative ideas.
- Project development Skills
- Problem analyzing skills
- Problem solving skills
- Creativity and imaginary skills
- Programming skills
- Deployment
- Testing skills
- Debugging skills
- Project presentation skills
- Thesis writing skills
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
6-2-85/B, Old Maternity Hospital Road, Thyagaraja Nagar, Tirupati, Andhra Pradesh – 517501
+91 9030333433
+91 9393939065
0877-2261612
Disclaimer - Takeoff Edu Group Projects are not associated or affiliated with IEEE in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, not projects of or by IEEE.
