I Foot; A Smart Insole for your foot
Also Available Domains Arduino
Objective
The main objective is to design an intelligent insole system provides great feasible supervision for health surveillance, injury prevention, and athlete training. We can monitor injured person recovery rate that from distinct rate
Abstract
The foot pressure measurement is important in gait and posture research for diagnosis of pressure of the feet for the athletes, back injuries, adaptation of insoles for orthopedic applications and prevention of diabetic foot ulceration. There are several methods to measure the distribution of foot pressure.
Smart insoles were designed and developed to measure real time foot plantar pressure. Key features of the insoles included cost-effectiveness, good working pressure detection range, wireless data transfer and real-time data analysis. Several commercially available in-shoe systems are designed with embedded pre-fabricated sensors in them. This restrains the density of the sensors in the insole, as they are limited by the size of individual sensors. With the miniaturization of sensors in order to achieve a higher density, the power consumption and cost of the insoles would be severely compromised.
Keywords: Arduino, WSN, Pressure Sensor, MEMS sensor, Bluetooth.
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
Hardware Requirements:
- Arduino uno
- Pressure sensor
- Bluetooth Module
- Power supply
- MEMS sensor
- Connecting wires
Software Requirements:
- Arduino IDE
- Embedded C
- Fritzing
- Bluetooth Mobile Application
Learning Outcomes
- Arduino uno Pin diagram and Architecture
- How to install arduino IDE Software
- Setting up and Installation procedures for Arduino uno
- Introduction to Arduino IDE
- Commands in Arduino uno
- Basics of Embedded C
- Working of MEMS sensor
- How to interface MEMS sensor with arduino uno?
- Working of pressure sensor
- How to interface pressure sensor with arduino uno?
- Introduction to Serial Communication
- Working of Bluetooth
- How to interface Bluetooth with Arduino uno?
- About Project Development Life Cycle:
- Planning and Requirement Gathering( software’s, Tools, Hardware components, etc.,)
- Schematic preparation
- Code development and debugging
- Hardware development and debugging
- Development of the Project and Output testing
- Practical exposure to:
- Hardware and software tools. ,
- Solution providing for real time problems,
- Working with team/ individual,
- Work on Creative ideas.
- Project development Skills
- Problem analyzing skills
- Problem solving skills
- Creativity and imaginary skills
- Programming skills
- Deployment
- Testing skills
- Debugging skills
- Project presentation skills
- Thesis writing skills
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
6-2-85/B, Old Maternity Hospital Road, Thyagaraja Nagar, Tirupati, Andhra Pradesh – 517501
+91 9030333433
+91 9393939065
0877-2261612
Disclaimer - Takeoff Edu Group Projects are not associated or affiliated with IEEE in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, not projects of or by IEEE.
