Covid Disinfectant Tunnel Using Face mask Detection & Temperature Monitoring
Objective
The main objective of this project is to detect face mask and monitor temperature for preventing from COVID infection
Abstract
Aiming at increasing safety control measures, this project is implemented to prevent transmission of corona virus. Since corona virus is transmitted through touch, this system helps children and people in home to be safe and monitors each people while entering. This system detects face mask and monitors temperature.
We propose a low-cost embedded system enabled COVID-19 standard operating procedure (SOP) compliance system that monitors body temperature and face mask identification. The system comprises of multiple sensor nodes communicating with a centralized controller.
Keywords: Arduino, Face Mask Detection, Python, Zigbee, Body Temperature, Covid19 Control Measures.
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
Hardware Requirements:
- Arduino
- Web Camera
- MLX9061 IR Temperature Sensor
- IR Sensors
- Relay
- DC Pump
- 100UF Capacitor
- Voice Module
- LCD
- Speaker
- Zigbee
- Power Supply Board
- 12V 500mA Transformer
Software Requirements:
- Embedded C
- Python IDLE
- Arduino IDE
Learning Outcomes
- Arduino pin diagram and architecture
- How to install Arduino IDE software
- Introduction to Python3 IDLE and Arduino IDE
- Commands in Python
- Basic coding in Python
- Working of MLX9061 IR Temperature Sensor
- Working of IR Sensor
- How to interface MLX9061 IR Temperature Sensor with Arduino?
- How to interface IR Sensor with Arduino?
- Working of LCD
- How to interface LCD with Arduino?
- How to interface Voice Circuit Module and Speaker with Arduino?
- Working of Zigbee
- How to interface Zigbee with Arduino?
- Face Mask detection using Python
- How the data Transmission happen between Arduino and laptop using Zigbee?
- Working on Power supply
- About Project Development Life Cycle:
- Planning and Requirement Gathering (Hardware components, etc.,)
- Hardware development and debugging
- Development of the Project and Output testing
- Practical exposure to:
- Hardware tools.
- Solution providing for real time problems.
- Working with team/ individual.
- Work on Creative ideas.
- Project development Skills
- Problem analyzing skills
- Problem solving skills
- Creativity and imaginary skills
- Testing skills
- presentation skills
- Thesis writing skills
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
6-2-85/B, Old Maternity Hospital Road, Thyagaraja Nagar, Tirupati, Andhra Pradesh – 517501
+91 9030333433
+91 9393939065
0877-2261612
Disclaimer - Takeoff Edu Group Projects are not associated or affiliated with IEEE in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, not projects of or by IEEE.
