Car Accident Location and Location Tracking
Objective
The main objective of this project is to find the vehicle where it is and locate the vehicle by means of sending a message when an accident occurs.
Abstract
Security in travel is primary concern for everyone. This project describes a design of effective alarm system that can monitor the vehicle / car condition, in travelling. The project name “car accident location and location tracking” shows that, the project is designed to prevent the accident and to inform emergency about an accident that has occurred. The purpose of the project is to find the vehicle where it is and locate the vehicle by means of sending a message using a system which is placed inside of vehicle system Most of the times we may not be able to find accident location because we don’t know where accident will happen. Our project Vehicle Tracking and Accident Detection is designed to avoid such situations.
This project presents an alert of the accident detection techniques by using MEMS Sensor. The purpose of the project is to find the vehicle where it is and locate the vehicle by means of sending a message using a system which is placed inside of vehicle system Most of the times we may not be able to find accident location because we don’t know where accident will happen.
Keywords: Arduino Uno,MEMS sensor, LCD, GSM, GPS, Buzzer, power supply
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
Hardware Requirements:
- Arduino Uno
- MEMS sensor
- Buzzer
- LCD
- GPS
- GSM
- Power supply
Software Requirements:
- Arduino IDE
Learning Outcomes
· Arduino pin diagram and architecture
· How to install Arduino IDE software
· Setting up and installation procedure for Arduino
· Introduction to Arduino IDE
· Basic coding in Arduino IDE
· Working of MEMS sensor
· Interface MEMS sensor with Arduino?
· Working of LCD
· Interface LCD with Arduino?
· Working of GSM
· Interface GSM with Arduino?
· Working of Buzzer
· Interface Buzzer with Arduino?
· Working of power supply
· Working of Motor driver and DC motor
· Interface Motor driver and DC motor with Arduino?
· About Project Development Life Cycle:
o Planning and Requirement Gathering( software’s, Tools, Hardware components, etc.,)
o Schematic preparation
o Code development and debugging
o Hardware development and debugging
o Development of the Project and Output testing
· Practical exposure to:
o Hardware and software tools.
o Solution providing for real time problems.
o Working with team/ individual.
o Work on Creative ideas.
· Project development Skills
o Problem analyzing skills
o Problem solving skills
o Creativity and imaginary skills
o Programming skills
o Deployment
o Testing skills
o Debugging skills
o Project presentation skills
o Thesis writing skills
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
6-2-85/B, Old Maternity Hospital Road, Thyagaraja Nagar, Tirupati, Andhra Pradesh – 517501
+91 9030333433
+91 9393939065
0877-2261612
Disclaimer - Takeoff Edu Group Projects are not associated or affiliated with IEEE in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, not projects of or by IEEE.
