Vehicle Safety and Accident Detection System Using IoT

Also Available Domains WSN|Arduino|ARM7|Raspberry pi

Project Code :TEMBMA2627

Objective

The main objective of the project is to collect crash recorder of the vehicle movements before, during and after a crash, through which an accident can be recognized. When an accident is occured, immediately the location will be sent to the hospital.

Abstract

This project is intended to deliver a vehicle safety and accident detection system. With an increase in population, there is an increase in the number of accidents that happen every minute. These road accidents are unpredictable. There are situations where most of the accidents could not be reported properly to nearby ambulances on time. In most of the cases, there is the unavailability of emergency services which lack in providing the first aid and timely service which can lead to loss of life by some minutes. Hence, there is a need to develop a system that caters to all these problems and can effectively function to overcome the delay time caused by the medical vehicles.

The purpose of this project is to introduce a framework using IOT, which helps in detecting car accidents and notifying hospitals immediately. This can be achieved by integrating smart sensors with a microcontroller within the car that can trigger at the time of an accident. The other modules like GPS and GSM are integrated with the system to obtain the location coordinates of the accidents and sending it to registered numbers and nearby ambulance to notify them about the accident to obtain immediate help at the location.

Keywords: Accident detection, Arduino uno, NodeMCU, IOT, Blynk App

NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.

Block Diagram

Specifications

Hardware Requirements:

  • Arduino UNO
  • NodeMCU
  • Keypad  module
  • MEMS sensor
  • GPS Module
  • Potentiometer
  • GSM Module
  • L293D Motor Driver
  • DC Motor
  • Power supply

Software Requirements:

  • Arduino IDE
  • Embedded C
  • Fritzing
  • Blynk App
  • Third Party server

Learning Outcomes

  • Arduino uno and NodeMCU Pin diagram and Architecture
  • How to install arduino IDE Software
  • Basic coding in embedded C
  • Working of L293D Motor driver
  • Interfacing L293D Motor driver with arduino uno
  • Working of Keypad module
  • Interfacing Keypad module with arduino uno
  • Working of MEMS sensor
  • Interfacing MEMS sensor with arduino uno
  • Working of potentiometer
  • Interfacing potentiometer with arduino uno
  • Interfacing DC motor with arduino uno
  • Introduction to serial communication
  • Working GSM, GPS module
  • How to interface GSM and GPS module with arduino uno?
  • Introduction to IOT
  • IOT scope and its architecture
  • How to give commands from Blynk App to nodemcu?
  • How to send serial data from nodemcu to arduino uno?
  • How to send data from NodeMCU to a third party server?
  • About Project Development Life Cycle:
    • Planning and Requirement Gathering( software’s, Tools, Hardware components, etc.,)
    • Schematic preparation 
    • Code development and debugging
    • Hardware development and debugging
    • Development of the Project and  Output testing
  • Practical exposure to:
    • Hardware and software tools.
    • Solution providing for real time problems.
    • Working with team/ individual.
    • Work on Creative ideas.
  • Project development Skills
    • Problem analyzing skills
    • Problem solving skills
    • Creativity and imaginary skills
    • Programming skills
    • Deployment
    • Testing skills
    • Debugging skills
    • Project presentation skills
    • Thesis writing skills

Demo Video

mail-banner
call-banner
contact-banner
Request Video

Related Projects

Final year projects