Design and Development of Three-Stage Industrial Car Washing System
Objective
The main objective of this project is to Develop Three stage Washing System like Spraying, Cleaning and Drying on a Single Setup
Abstract
Car wash systems allow for fully automated car wash in a short amount of time. Here we demonstrate a smart car wash system that allows for completely automated car washing process. The system consists of a 3-stage car wash system. The system consists of a small conveyor type belt that holds on to a car. The system has an IR sensor to check if a car has been parked in the system. On detection the system now starts the belt movement using a motorized system and vehicle moves to the first stage and starts washing the car for some time and the conveyor starts moving again and in 2nd stage brushes are used to clean the cars in 3rd stage fan will ON and make the car dry and starts the conveyor belt so that the car went out of the cleaning place.
Keywords: Car Washing, Automatic Process, 3 stage process.
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
Hardware Requirements:
- Arduino
- IR Sensors
- Relays
- DC Pump
- DC Motors
- DC Fan
- Power Supply
Software Requirements:
- Arduino IDE
- Embedded C
- Fritzing
Learning Outcomes
- Arduino pin diagram and architecture
- How to install Arduino IDE software
- Setting up and installation procedure for Arduino
- Introduction to Arduino IDE
- Basic coding in Arduino IDE
- Working of DHT11 sensor
- Interface DHT11 sensor with Arduino?
- Working of Soil moisture sensor
- Interface Soil moisture with Arduino?
- Working of Relay
- Interface Relay with Arduino?
- Working of Pump motor
- Interface Pump motor with Arduino?
- Working of power supply
- About Project Development Life Cycle:
- Planning and Requirement Gathering( software’s, Tools, Hardware components, etc.,)
- Schematic preparation
- Code development and debugging
- Hardware development and debugging
- Development of the Project and Output testing
- Practical exposure to:
- Hardware and software tools.
- Solution providing for real time problems.
- Working with team/ individual.
- Work on Creative ideas.
- Project development Skills
- Problem analyzing skills
- Problem solving skills
- Creativity and imaginary skills
- Programming skills
- Deployment
- Testing skills
- Debugging skills
- Project presentation skills
- Thesis writing skills
Demo Video
Request for Video
Related Projects
Paper Publishing
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
Disclaimer - Takeoff Edu Group Projects, are not associated or affiliated with IEEE, in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, and not projects of or by IEEE.
