Paper PublishingAdvanced Traffic Violation Control and Penalty System with Web Server
Also Available Domains WSN|IOT|Raspberry pi|Arduino
Objective
The main objective of this project is to create an intelligent traffic violation detection and traffic flow analysis system to monitor and measure red light jumping.This system is based upon RFID technology for identification of vehicles on the road and OpenCV, IoT for charging the vehicle for jumping red light.
Abstract
This project is intended to deliver an intelligent traffic system using Radio Frequency Identification (RFID) technology. It is designed and implemented in a way where fines are autonomously registered. Low cost equipment has been used such as RFID technology, passive tags, processing unit (personal computer), and a connection system. Initially the data is collected using the RFID, where it reads any identified tag that attached with vehicles and then a certain data is transmitted to the server using internetwork communication system.
Now-a-days the modern technology is improving day by day to facilitate the daily life people task. One of the big challenges in developing cities is traffic management due to increasing of population density and number of vehicles in the cities. Road congestion leads to wasting time and fuel which is effectively rise the environmental pollution. This project show that Internet of Things (IoT) would be feasible and cheap for constructing traffic management system.
Keywords: RFID Technology, IoT, Raspberry Pi
NOTE: Without the concern of our team, please don't submit to the college. This Abstract varies based on student requirements.
Block Diagram
Specifications
- Hardware Requirements:
- Raspberry pi
- Camera
- GSM
- Micro SD Card
- RFID Reader
- RFID tag
- LCD
- LEDs (Traffic Light)
- Software Requirements:
- NOOBS Software
- Python 3 IDE
- VNC viewer
- Fritzing
- SMTP Server
Learning Outcomes
- Raspberry Pi Pin diagram and Architecture
- How to install NOOBS Software
- Setting up and Installation procedures for Raspberry Pi
- How to connect Raspberry Pi through VNC viewer?
- Introduction to Python3 IDE
- Commands in Python
- Basic coding in Python
- Introduction to serial communication
- Working of GSM
- Interface of GSM with Raspberry Pi
- What is WSN?
- Working of RFID
- Interface of RFID Reader with Raspberry Pi
- Interface LCD with Raspberry pi
- What is OPENCV?
- How to install libraries required for interfacing camera with Raspberry Pi?
- Interface camera with Raspberry pi
- What is IOT and its architecture?
- How to send mail using Raspberry Pi?
- About Project Development Life Cycle:
- Planning and Requirement Gathering(( software’s, Tools, Hardware components, etc.,)
- Schematic preparation
- Code development and debugging
- Hardware development and debugging
- Development of the Project and Output testing
- Practical exposure to:
- Hardware and software tools.
- Solution providing for real time problems.
- Working with team/ individual.
- Work on Creative ideas.
- Project development Skills
- Problem analyzing skills
- Problem solving skills
- Creativity and imaginary skills
- Programming skills
- Deployment
- Testing skills
- Debugging skills
- Project presentation skills
- Thesis writing skills
Request Call Back
Would you like to receive a free callback now?
Choose the best time for callback:
Leave your message and we will contact you as soon as possible
Disclaimer - Takeoff Edu Group Projects, are not associated or affiliated with IEEE, in any way. The IEEE Projects mentioned here are mentioned in the context of student projects, whose ideas are derived from IEEE publications, and not projects of or by IEEE.
